2018–2024 Chevrolet Equinox 1.5L turbo
Engine air filter
Good first job: 2 tools, no lifting, about 20 min
That's the free part.
The full video is 1:27: all 11 steps on the 2018–2024 Chevrolet Equinox 1.5L turbo, start to finish.
One-time $1. Not a subscription.$1
- One-time $1. Not a subscription. No account.
- Wrong video for your car? Reply to your Stripe receipt within 7 days for a full refund.
- Secure checkout by Stripe. Terms
Send it to someone
Lid bolts4, snug only
Breather hoseLeave it on
Filter boxPassenger side
AfterReset filter life
What you need
Links open Amazon.
As an Amazon Associate I earn from qualifying purchases.
Every step in this video (11)
- Engine off, hood up. The filter box is on the passenger side, right behind the headlight.
- The airflow sensor and the intake duct connect to the lid. The duct runs down to the turbo.
- Step 1: unplug the sensor. Pull the plug, not the wire.
- Step 2: loosen the duct clamp at the box only, and slide the duct off the lid. Leave the small breather hose alone. Once it's off, it has to be replaced.
- Step 3: take out the four lid bolts.
- Step 4: lift off the lid, then the old filter. Note which way it sat.
- Step 5: wipe out any leaves and dirt.
- Step 6: set the new filter in the same way, tab in its notch, rubber edge flat all around.
- Step 7: set the lid on and start the bolts by hand. Snug only. They thread into plastic.
- Step 8: push the duct fully on, tighten the clamp, and plug the sensor in until it clicks.
- Last check: lid flat, duct on straight, clamp tight, sensor plugged in. If your dash shows air filter life, reset it.
Written by our repair experts, checked against real jobs mechanics logged. If your owner’s manual says something different, go with the manual.
Look up another car All videos